LG UUC1.U40 (8 kW) - outdoor unit for server rooms, single-phase supply
Description LG UUC1.U40
The UUC1.U40: an 8 kW outdoor unit for server rooms
The UUC1.U40 is the outdoor unit of an LG pair intended for server rooms and technical spaces: 8 kW cooling and 9 kW heating. The casing is 950 mm wide, 834 mm high and 330 mm deep, the supply is single-phase 220-240 V, 50 Hz, the refrigerant is R32 and the compressor is a Dual Inverter. Manufacturer country and country of origin are Korea, the warranty is 24 months and the construction is metal with plastic parts. The indoor half of the pair is the US30F (item 1848) at the same capacity; ordering them separately makes no sense, as they work only together. It is the outdoor unit that determines whether the system can cool the room in frost, which makes it more important for a server room than any indoor option.
How an outdoor unit for server rooms differs
An ordinary domestic unit cools in summer and heats in winter, and its electronics are tuned for exactly that. A server room needs the opposite: cooling all year, including when it is below zero outside. That changes the requirements - fan speed control at low condensing temperatures, protection against icing, and compressor operation in a regime domestic equipment never sees. The practical consequence for a buyer is simple: a server-room pair is not assembled from any two units of matching capacity, but is the specific combination the manufacturer states for this application. We check the exact lower limit for cooling in the combination data sheet before the sale and confirm it in writing - it is the main parameter by which equipment for a server room is chosen at all.
Installation: position, wind and snow
An outdoor unit for a server room works through the winter, so its installation differs from a summer-only scenario. The base is a frame or brackets raising it above snow level: a unit standing on the ground without that works half buried in a snowy winter and loses capacity. Wind blowing straight into the coil is undesirable, so on an exposed facade a wind screen is fitted - one that scatters the flow without blocking it. Free drainage of melt water is provided underneath: in winter condensate and frost build ice, and if the water cannot escape the ice rises to the bottom panel. On a roof the unit is placed where it can be reached in any season - server room equipment has to be serviced in January too, not only in good weather.
Power supply: a dedicated circuit, protection, and the UPS question
A single-phase unit of 8 kW cooling needs its own circuit with a breaker and cable sized by calculation - feeding it from a socket in the corridor is not acceptable even temporarily. The second question always arises in server rooms: can the air conditioner be connected to the UPS. Usually not - a UPS is sized for the IT load, and the starting and running current of climate equipment eats its runtime quickly; the right approach is to connect the air conditioner to the generator, or to a circuit that comes back up together with the servers. The third is surge protection: a supply that dips causes protection trips, and for equipment running around the clock the protection pays for itself with the first thunderstorm. All three are settled in the electrical design rather than after the first incident.
Winter and heat: two opposite tasks
A server room loads the air conditioner all year, but the task differs with the season. In summer the point is to reject heat at over thirty degrees outside, and it is critical that hot air from the unit does not return to its own coil: minimum clearances to walls and neighbouring equipment are observed strictly. In winter the point is to keep cooling reliably below zero without falling into constant defrost cycles or icing up. The system switches between these regimes by itself, but its ability to work at both ends of the range is built into this particular outdoor model. If free cooling with outdoor air is planned for the cold season, that is a separate system with filters and dampers, designed alongside the air conditioner rather than instead of it.
Servicing the outdoor unit
An outdoor coil collects whatever is in the air around it: poplar fluff in summer, leaves in autumn, road dust all year. A fouled condenser raises system pressure, increases consumption and shortens compressor life, so it is washed at least once a year and twice in dusty locations. The job is simple but has to be done properly: moderate water pressure, the jet along the fins rather than across them, or the fins bend and the result is the opposite of the intention. Along with the wash, the electrical connections, the resilient mounts, the fixings and the drain under the unit are checked. For a server room these visits are planned together with the indoor unit's service, so that the system is inspected as a whole and on schedule rather than after it stops.
The pair, redundancy, and what happens when it stops
The UUC1.U40 with a US30F covers an IT load of about 6-6.5 kW with a margin, which is enough for a small server room. But one pair is one point of failure, so rooms with critical equipment get two sets with automatic rotation managed by an AC Smart 5 central controller (item 1907). For a larger load the same line offers the bigger pair: the US36F indoor unit (item 1850) and the UUD1.U30 outdoor unit (item 1851) at 9.5 kW cooling. It is worth calculating in advance how many minutes it takes for the room to reach a critical temperature once cooling stops - in a densely packed room that is tens of minutes rather than hours. With that figure in hand it is easier to decide whether a second set is needed or fast service plus alerting will do.
Tell us what equipment the room holds and which temperature is critical for you, and we will match the pair, calculate the margin and propose a redundant arrangement if one is warranted. We will also advise on the right position for the outdoor unit allowing for winter, snow and service access.
Characteristics LG UUC1.U40
Reviews about LG UUC1.U40 from real users
No reviews found




