LG MU5R30 (8.8 kW) - multi-split outdoor unit for 5 indoor units
Description LG MU5R30
The MU5R30: five indoor units on one outdoor
The MU5R30 is the outdoor unit of an LG R32 multi-split system rated at 8.8 kW cooling and 10.1 kW heating for five indoor units. The casing is 950 mm wide, 834 mm high and 330 mm deep, the supply is single-phase 220-240 V, 50 Hz, the compressor is a Dual Inverter and the construction is metal with plastic parts. Manufacturer country and country of origin are Korea, with a 24-month warranty. Indoor units come from the multi range: the MA09R and MA12R wall units (items 1866-1867), the MJ05PC to MJ24PC (items 1868-1874), the MT09R and MT11R cassettes (items 1875-1876). Five ports is the top of the domestic multi range, and beyond it there is only the more powerful MU5R40 (item 1859).
Five rooms: the sensible limit for one system
A five-unit multi is an engineering project rather than the purchase of an air conditioner for a room. The more indoor units on one compressor, the more the design has to be coherent: simultaneity calculated, pipe runs measured, drains thought through, the outdoor position chosen properly. In a private house five units usually means the living room, an open-plan kitchen and three bedrooms, or four rooms plus a study. When there are more than five rooms, the right path is not to look for a six-port system but to split the building between two systems: dearer at the outset, but more reliable and more flexible in use. The second advantage of splitting is that two independent machines mean one failure does not leave the whole house without climate control.
Uneven loads: how to divide 8.8 kW
The typical arrangement for a house is one large unit in the living room or open kitchen and four smaller ones in bedrooms and a study. For example, 18,000 BTU in the living room plus four units of 7,000 to 9,000 - the sum of the ratings comes out above 8.8 kW, and that is fine if the bedrooms run at night and the living room by day. If all five rooms are used during the hottest hours, however, each gets a smaller share, and the largest room notices it first. So a big glazed living room is better given its own margin, while bedrooms are sized precisely. We verify the permitted combinations and the maximum overlap ratio for the MU5R30 against the manufacturer's table before the order, because not every set of units is accepted.
Electrics: 8.8 kW of cooling from one phase
A single-phase supply for a system this size means a substantial running current, so the electrical side is planned together with the climate system rather than after it. The outdoor unit gets its own circuit with a breaker and a cable sized by calculation, allowing for the distance from the board: on a long run the cross-section is increased, or the terminal voltage dips during starting. If the house has a three-phase supply, the system goes on the least loaded phase and the overall balance is checked - otherwise an evening with the water heater and the hob on the same phase trips the breaker. Surge protection is worth its money on equipment with an inverter compressor: the electronics are the most sensitive part to spikes in the supply. In houses with a generator it is checked separately whether it can carry the start, and whether starting the air conditioner should be blocked while running on generator.
A guest house, an office, several let rooms
For a small guest house or hostel of five rooms a multi system looks attractive: one unit on the facade, five rooms with their own handsets. But there are two features to note. First, all the rooms share one mode: in the shoulder seasons some guests will want heat and others cooling, and the system will not allow it, which generates complaints. Second, control: guests set 17 degrees and leave with the window open, so central control with a limited setting range and the ability to switch units off on a schedule is needed. For such buildings we recommend the AC EZ central controller (item 1905) or the AC EZ Touch (item 1906) with a touchscreen - they let the manager see the state of every unit without walking the corridors. A third option for a guest house is to split the installation into two smaller systems, so rooms on different sides of the building can run in different modes.
Central control of five units
Five handsets go missing faster than three, so for systems like this central control is convenience rather than luxury. The AC EZ (item 1905) works with a network of up to 32 indoor units; the AC EZ Touch (item 1906) handles up to 64 and has a touchscreen, which suits premises with staff. Networking uses the PI485 PMNFP14A1 module (item 1904), and control from a phone uses the PWFMDD202 Wi-Fi module (item 1903), which works on the 2.4 GHz band. The practical value of central control shows in simple things: pressing switch everything off once before leaving, seeing that the child's room was left running, setting a schedule for the night. In a house with five units that saves more frustration than any individual feature of the air conditioners themselves.
Servicing a system with five indoor units
The workload grows in proportion: five sets of filters, five drain lines, five indoor coils and one outdoor. Filters are washed monthly during the season, and that is the owner's job rather than the engineer's - it takes minutes and has the greatest effect on efficiency. Once a year a full visit is needed: cleaning the coils, checking pressures and current, flushing the drains, tightening electrical connections. On a system with a long total pipe run, pressure trends are watched particularly closely: a slow leak on one of five lines shows up not as a fault but as a gradual loss of performance across the whole system. If every visit is logged with figures, the cause is found in half an hour instead of a day of searching.
Thinking ten years ahead
A five-unit multi lasts a long time, so it is worth thinking about what happens when the equipment has to be replaced. First: keep the pipe route drawing with actual lengths and diameters - without it the next installer works blind. Second: the outdoor unit's position should still be accessible years later, not closed in by an extension or overgrown by trees. Third: R32 is today's standard for systems of this kind, but regulations change, and copper pipework usually outlives several generations of equipment, so its quality and diameters matter for the future. Fourth: do not bury joints in a wall without access - every brazed point should stay within an inspection hatch or a reachable zone. These four things cost practically nothing at installation and decide, ten years later, whether the job is an equipment swap or a refurbishment with broken walls.
Describe the five rooms - areas, orientation, how they are used - and we will calculate the capacities, verify the combination against the manufacturer's table and say whether splitting the building between two systems would serve you better. We will also propose central control if five handsets in a house sound like four too many.
Characteristics LG MU5R30
Reviews about LG MU5R30 from real users
No reviews found




