Catalogue

LG MJ09PC (9,000 BTU, 2.5 kW) - wall multi-split indoor unit, 1/4 and 3/8 pipes

CL-000944
24 86000 ₴
Out of stock
14 days
Our advantages
Delivery terms and cost
Payment options

Description LG MJ09PC

The MJ09PC: the commonest size in the multi range

The MJ09PC is a wall-mounted indoor unit for LG multi systems: 2.5 kW cooling, 3.2 kW heating, 9,000 BTU. The casing is 818 mm wide, 316 mm high and 189 mm deep; refrigerant R32, supply 220-240 V, 50 Hz. The pipes are 1/4 inch (6.35 mm) for liquid and 3/8 inch (9.52 mm) for gas, the maximum pipe length is 15 metres and the permitted height difference is 10 metres. Manufacturer country and country of origin are Korea, the warranty is 24 months and the construction is metal with plastic parts. A nine is the commonest size in homes, and this unit is most often the baseline in a multi system specification.

Why there is more heating than cooling

The card shows something interesting: 2.5 kW cooling and 3.2 kW heating. That is not an error but a property of a heat pump: in heating mode the heat brought in from outside is joined by the heat of the compressor's own work, so the heating output comes out higher than the cooling output. The practical conclusion is simple: a unit adequate for cooling a room will heat it with margin in the shoulder seasons. But the limitation matters: the stated 3.2 kW is obtained under nominal conditions, and output falls as the outdoor temperature drops. So in January at minus fifteen the system will deliver less, and relying on it as the only heat source in hard frost is unwise.

The rooms 9,000 BTU suits

2.5 kW of cooling corresponds roughly to eighteen to twenty-five square metres at normal ceiling height, with one window and moderate glazing. Such a unit works well in a large bedroom, a study, a small living room, a teenager's room. If the room has a panoramic south or west window, or sits under a hot roof, take the next step up - the MJ12PC (item 1871). If the room is under fifteen metres with a north window, a nine is already too much: an MJ07PC (item 1869) will run more evenly. There is also a special case - the kitchen: even a small kitchen with a hob and a fridge is loaded more heavily than a bedroom of the same size, and there a nine is the minimum.

15 metres of pipe and 10 metres of height in practice

These figures define the geometry of the installation. Fifteen metres is the maximum pipe length from the branch to this indoor unit, measured along the actual route with every bend and rise. In a typical flat that is ample, but in a long flat with a unit in the far room the route is worth measuring with a tape before installation. Ten metres of height difference is about three storeys, so a house with the unit on the first floor and the outdoor unit at ground level is within limits. The third constraint is the total length of all the system's lines, and it often proves tighter than the limit on a single line. One practical nuance: beyond the base length the system is topped up with refrigerant by calculation, so a long run means not only metres of pipe but extra work.

MJ09PC or the square MA09R: an honest comparison

The catalogue holds two 9,000 BTU units for multi systems: this one and the square MA09R (item 1866) with its 600 by 600 mm casing. Their cooling output is effectively the same - 2.6 against 2.5 kW makes no practical difference - so the choice is purely about format and budget. The MJ09PC is a conventional 818 mm panel: a wider airflow, better suited to a long room, and usually more affordable. The MA09R is a square that reads as part of the interior and fits in a narrow pier where a panel will not. Our advice is simple: in bedrooms and studies, where the unit simply works, take the MJ09PC; in a room where appearance matters - a living room with a designed interior - paying more for the square format makes sense.

Installation: height, clearances, direction

The unit is hung high, with the clearances from ceiling and side walls given in the manual - air has to enter the intake grille freely, or capacity falls. The airflow direction is planned at once: cold air should not blow at a person, so in a study the unit does not go behind a desk, and in a bedroom not above the bed. The drain runs by gravity with a continuous fall to the discharge point; where that is impossible a condensate pump is needed, and it is better to establish that before choosing the position rather than after drilling the wall. In a finished interior the pipework and cable run in trunking, and its route is agreed in advance - this is where misunderstandings with owners most often arise. Last: the panel has to open for filter access, so furniture beneath the unit or a wardrobe flush against its side is a bad idea.

Quiet operation, and what actually makes noise

In a multi system there is no compressor in the room, and that is the main reason an indoor unit runs quietly: only the fan is audible. At minimum speed that is a background rustle; at maximum it is noticeable air noise, which is why auto mode is more comfortable than a permanently high setting. The second factor is correct sizing: a unit with a large margin ramps up and stops, and it is those changes that disturb, not a steady sound. The third is installation: a loosely fixed casing, a pipe touching the wall or a drain line without a fall add noises often mistaken for a fault. The fourth is filter condition: a clogged filter forces the fan to work harder for the same airflow, and the noise rises together with the consumption.

What else the unit needs to work

The MJ09PC is an indoor unit for a multi system; it does not work alone and does not come with an outdoor unit. An MU series outdoor unit is selected for it: the MU2R15 or MU2R17 (items 1852-1853) for two rooms, the MU3R19 or MU3R21 (items 1854-1855) for three, and so on by room count. The combination is verified against the manufacturer's table - the system may not accept an arbitrary set. In addition you buy 1/4 and 3/8 inch copper pipe with insulation, the interconnecting cable, fixings, drain tubing and materials for the wall penetration. If control without a handset is wanted, add a PREMTB001 wired controller (item 1897) or the PWFMDD202 Wi-Fi module (item 1903), which works on a 2.4 GHz network.

Send us the areas and orientation of the rooms and we will say where a nine is enough and where a step up is needed, then select the outdoor unit for the whole system. If you are choosing between a conventional panel and the square format, we will explain the difference in operation, not only in looks.

Characteristics LG MJ09PC

Gas pipe
3/8 (9.52) inch/mm
Installation type
Wall
Liquid pipe
1/4 (6.35) inch/mm
Max. pipeline length
15 m.
Electrical properties
Current frequency
50Hz
High-voltage
220 - 240В.
General characteristics
Appointment
Внутрішній блок (мульти-спліт)
BTU
9
Compressor type
Dual Inverter
Country of origin
Корея
Country of origin
Корея
Elevation difference
10 m.
Guarantee
24 months
Refrigerant
R32
Type
Мульти-спліт
Manufacturer
LG
Overall dimensions
Indoor unit height
316 мм.
Indoor unit length
189 мм.
Indoor unit width
818 мм.
Physical properties
Material of execution
Combination of metal and plastic
Thermal properties
Cooling capacity
2500 Вт.
Thermal efficiency
3200 Вт.
Find similar

Reviews about LG MJ09PC from real users

No reviews found

Store addresses
Working hours
Телефон
Availability
Maybe it will interest you
  • Recently viewed
  • Most popular
  • Sale
 
 
 
Швидко і якісно достявляємо

Наша компанія виконує доставку по всій Росії і ближньому зарубіжжі

Гарантія якості і сервісне обслуговування

Ми пропонуємо тільки ті товари, в якості яких ми впенені

Повернення товару протягом 30 днів

У вас є 30 днів, для того щоб протестувати вашу покупку