Catalogue

LG MA09R (9,000 BTU, 2.6 kW) - square 600x600 mm indoor unit for multi systems

CL-000940
42 94000 ₴
Out of stock
14 days
Our advantages
Delivery terms and cost
Payment options

Description LG MA09R

The MA09R: a square 600 by 600 mm indoor unit

The MA09R is a wall-type indoor unit for LG multi systems: 2.6 kW cooling and 2.9 kW heating, equivalent to 9,000 BTU. Its distinguishing feature is the shape of the casing: a 600 by 600 mm square only 145 mm deep, instead of the familiar elongated panel. Refrigerant R32, supply 220-240 V, 50 Hz, pipe sizes 1/4 inch (6.35 mm) for liquid and 3/8 inch (9.52 mm) for gas. The maximum pipe length to this unit is 15 metres and the permitted height difference is 10 metres. Manufacturer country and country of origin are Korea, the warranty is 24 months and the construction is metal with plastic parts.

The square format: not only about looks

An ordinary wall unit is 80 to 100 cm wide and reads as a piece of technical equipment above a window or door. A 600 by 600 square reads differently: it sits in the wall like a panel, and where the interior matters that is the decisive argument. There is a practical advantage too: such a unit fits where an elongated panel will not - in a narrow pier, between wardrobes, above a short stretch of wall beside a window. At 145 mm the depth is less than most wall models, so the unit protrudes less into the room, which is noticeable in a hallway or a small bedroom. The price of that compactness is less coil area per kilowatt, which is why these models stop at around 12,000 BTU - the format is not intended for a large living room.

9,000 BTU: which rooms it suits

2.6 kW of cooling corresponds roughly to a room of eighteen to twenty-five square metres at normal ceiling height, with one window and moderate glazing. The exact figure depends on orientation: the same bedroom with a north window needs less, while one with a panoramic west window needs more, because it takes the sun during the hottest hours. For a top-floor room under a hot roof a margin is essential. In a small bedroom of ten to twelve metres, however, a nine is already too much: it reaches temperature quickly, stops and then works in bursts, which is worse both for comfort and for dehumidification. For that case the range offers the MJ05PC (item 1868) at 5,000 BTU and the MJ07PC (item 1869) at 7,000 - they will run more evenly.

It works only in a multi system

This matters before ordering: the MA09R is not a standalone air conditioner and does not come with an outdoor unit. It is intended for multi systems, so an outdoor unit from the MU series is selected separately - from the MU2R15 (item 1852) for two rooms to the MU5R40 (item 1859) for five. Indoor units from ordinary splits and the outdoor units of single systems will not work with it, and vice versa. The second thing to allow for: the number and mix of indoor units is constrained by the manufacturer's combination table, which we check before the order. The third: if you need one room and one outdoor unit, a multi system is not for you - an ordinary split will be cheaper and simpler.

15 metres of pipe and 10 metres of height: what that means

These two numbers determine where the unit can physically sit relative to the outdoor one. Fifteen metres is the maximum pipe length to this indoor unit, and it is measured along the actual route with every bend, not as a straight line across the flat. For a typical two-room flat that is ample; in a long flat with the far room at the other end the limit is worth checking with a tape measure. Ten metres of height difference is about three storeys, so a unit in an attic with the outdoor unit at ground level is within limits - again, allowing for the real route. There is a third constraint often forgotten: the total length of all the lines in a multi system is also limited, so two long runs together can exceed it even when each is individually fine.

Mounting on the wall: height and airflow direction

A square unit is hung as high as any wall unit - close to the ceiling, with the clearances from walls and ceiling given in the manual, so that air enters the grille freely. The main rule about position concerns the airflow: cold air should not blow at a person - not at a desk, not at a bed, not at a sofa. In a bedroom the unit most often goes above the door or on the wall to the side of the bed, so the air travels over your head towards the opposite wall. The second rule is drainage: condensate must be able to leave the unit with a continuous fall to the discharge point, and that is often what rules out the prettiest positions. The third is access: the panel has to open so the filters can be reached, so a unit tucked behind a curtain in a corner makes servicing awkward for years.

Quiet in a bedroom, and night mode

In a multi system the compressor is outside, so only the indoor fan runs in the room, and at minimum speed that is a quiet background rustle. For a bedroom this is the arrangement's main advantage: the noise that wakes people is usually not a steady sound but a change - the unit ramping up after a stop. That is exactly why correctly chosen capacity matters more than a night mode: a unit with a big margin will work in bursts whatever the settings. The second source of noise is installation: a poorly fixed unit, or pipework touching the wall, transmits vibration through the structure. The third is the fan setting: automatic mode is often more comfortable at night than a fixed high speed, because the system lowers the airflow itself once the temperature is reached.

Maintenance: filters, smells, cleaning

The routine is simple: the coarse filters are taken out and washed once a month during the working season, dried and put back. It takes a few minutes and has the greatest effect: a clogged filter reduces airflow and capacity and increases consumption. If an unpleasant smell appears on start-up after winter, the cause is almost always the same - a damp coil and tray with a season's biological film; the answer is professional cleaning rather than air fresheners. The prevention is well known too: before switching off for a long period, leave the unit in fan mode for half an hour so the coil dries. Once a year it is worth scheduling a service visit with coil cleaning and checks on drainage and system pressure - in a multi system that is done for all the units at once.

Tell us which rooms the units are for and their areas and orientation, and we will choose the capacities, the matching outdoor unit and verify the combination against the manufacturer's table. If the unit's appearance in the interior matters to you, we will say where the square format genuinely wins and where a conventional panel is the better choice.

Characteristics LG MA09R

Gas pipe
3/8 (9.52) inch/mm
Installation type
Wall
Liquid pipe
1/4 (6.35) inch/mm
Max. pipeline length
15 m.
Electrical properties
Current frequency
50Hz
High-voltage
220 - 240В.
General characteristics
Appointment
Внутрішній блок (мульти-спліт)
BTU
9
Compressor type
Dual Inverter
Country of origin
Корея
Country of origin
Корея
Elevation difference
10 m.
Guarantee
24 months
Refrigerant
R32
Type
Мульти-спліт
Manufacturer
LG
Overall dimensions
Indoor unit height
600 мм.
Indoor unit length
145 мм.
Indoor unit width
600 мм.
Physical properties
Material of execution
Combination of metal and plastic
Thermal properties
Cooling capacity
2600 Вт.
Thermal efficiency
2900 Вт.
Find similar

Reviews about LG MA09R from real users

No reviews found

Store addresses
Working hours
Телефон
Availability
Maybe it will interest you
  • Recently viewed
  • Most popular
  • Sale
 
 
 
Швидко і якісно достявляємо

Наша компанія виконує доставку по всій Росії і ближньому зарубіжжі

Гарантія якості і сервісне обслуговування

Ми пропонуємо тільки ті товари, в якості яких ми впенені

Повернення товару протягом 30 днів

У вас є 30 днів, для того щоб протестувати вашу покупку