Catalogue

LG CT18R (18,000 BTU, 5 kW) - compact cassette indoor unit 256 mm high

CL-000910
44 74800 ₴
Out of stock
14 days
Our advantages
Delivery terms and cost
Payment options

Description LG CT18R

The CT18R: 5 kW in a compact cassette body

The CT18R is a cassette indoor unit from LG's R32 semi-industrial range delivering 5 kW of cooling and 5.8 kW of heating. On plan it stays compact at 570 by 570 mm, like the smaller CT09R and CT12R, but the casing has grown from 214 to 256 mm in depth. It runs on 220-240 V, 50 Hz, uses R32, pairs with a Dual Inverter compressor and has a metal casing with plastic parts; manufacturer country and origin are Korea and the warranty is 24 months. The decorative panel is ordered separately - for the 09-18 kBTU range that is the PT-QAGW0 (item 1915). This model's card carries no pipe diameters, maximum run or height difference: we take those from the data sheet for the chosen pair and pass them on before installation, so that the crew arrives with the right copper.

The forty-two millimetres that decide everything

The height difference between a CT12R and a CT18R looks trivial until you have to replace a unit in a finished ceiling. A 256 mm casing needs a void of about 320-340 mm once resilient mounts, drain fall and pipe insulation are counted, where the twelve managed with 280-300 mm. In a new design that changes nothing; in an office refit where the ceiling was hung ten years ago around an older cassette, the clearance has to be measured at several points, because a structural slab is rarely perfectly flat and one corner of the room may be short. If the height is not there and 5 kW is what you need, there are ways out: the UV18R ceiling-suspended unit (item 1842) hangs in the open below the slab, and the CL18R ducted unit (item 1826) is only 190 mm deep. That check belongs before payment, because returning installed equipment is always a long story.

Five kilowatts from a single ceiling module

What makes the CT18R interesting is power density: the same 570 mm footprint delivers twice the cooling of the nine. The price is a higher airflow through the same grille area, which means faster air and more audible noise at maximum fan speed. In practice the unit rarely runs flat out, since an inverter pair settles at middling speeds, but on a quiet night shift or in a meeting room it is worth bearing in mind when choosing the mode. As a guide, 5 kW suits 45-55 m² at normal height, moderate glazing and an ordinary amount of equipment. In a room close to square, one such cassette distributes air more evenly than two smaller units in opposite corners, and this is exactly the case where a compact body works in the interior's favour.

One 5 kW cassette or two smaller ones

For a 50 m² room there are two routes: a single CT18R in the centre, or a pair of CT09R or CT12R units spread along the room. One unit installs more cheaply - one pipe run, one drain, one power connection - and occupies a single ceiling module instead of two. Two smaller cassettes win in an elongated room, or where a partition, a column or a tall cabinet breaks the airflow: two centres of distribution cover that geometry more evenly. There is an operational argument too: if one machine stops, the other still holds half the load, which matters in a server room or a sales floor where losing cooling is not acceptable. Our usual advice is one unit for a square room and a pair of smaller ones for a hall longer than about nine metres.

When a cassette is not the right answer

A cassette does poorly where the air carries grease, dust or moisture: above a restaurant kitchen, in a joinery workshop, in a laundry. The coil clogs within a season, the filter stops helping, and cleaning a cassette is harder than cleaning a ducted unit reachable from the side. The second limit is height: above about 3.5-4 metres the flow from the ceiling no longer reaches people with any useful velocity, and in heating the warmth simply stays aloft. The third is a room with no suspended ceiling at all - you cannot cut an opening in a structural slab, so a wall, floor-ceiling or ceiling-suspended unit is used instead. In those cases we point to the UV18R (item 1842) or a ducted model rather than selling a cassette into a situation that will disappoint quickly.

The outdoor pairing and what to confirm in advance

The matching outdoor unit for 5 kW cooling and 5.8 kW heating is the UU18WR (item 1814), measuring 870 by 650 by 330 mm. Since the CT18R card carries no pipe diameters or maximum run, those figures come from the data sheet for the pair: they depend on the combination, and a mistake here means redoing copper pipework rather than changing a setting. Three things are worth knowing before ordering: where the outdoor unit will stand, what the pipe run will actually measure, and whether the condensate can leave by gravity. The first determines length and any additional charge, the second the capacity lost along the way, the third whether an extra pump is needed. We confirm this before dispatch because those details change the kit list, not because we enjoy correspondence.

Living with it: filter, tray and that smell

The filter withdraws downwards through the panel grille - a two-minute job the occupants do themselves, monthly in an occupied room and more often where there is dust. The tray and the condensate pump belong to service and are checked once a year, and that is where the characteristic smell people complain about after two or three years is born. The cause is not the refrigerant but biofilm on a damp coil and in the tray, so prevention means washing with an antibacterial agent rather than an air freshener in the room. A useful habit: switch to fan-only for a few minutes before shutting the unit down so that the coil dries - some models do this automatically, and the function is worth enabling. Regular maintenance costs less than a new tray and gives back the capacity an owner had written off as lost for good.

We will check the depth of your ceiling void, match the outdoor unit and panel, and give you exact pipe diameters from the combination data sheet. Send the room dimensions and a photo of the ceiling - that is usually enough for a calculation.

Characteristics LG CT18R

Installation type
Касетний
Electrical properties
Current frequency
50Hz
High-voltage
220 - 240В.
General characteristics
Appointment
Напівпромисловий
BTU
17
Compressor type
Dual Inverter
Country of origin
Корея
Country of origin
Корея
Guarantee
24 months
Refrigerant
R32
Type
Split system
Manufacturer
LG
Overall dimensions
Indoor unit height
256 мм.
Indoor unit length
570 мм.
Indoor unit width
570 мм.
Physical properties
Material of execution
Combination of metal and plastic
Thermal properties
Cooling capacity
5000 Вт.
Thermal efficiency
5800 Вт.
Find similar

Reviews about LG CT18R from real users

No reviews found

Store addresses
Working hours
Телефон
Availability
Maybe it will interest you
  • Recently viewed
  • Most popular
  • Sale
 
 
 
Швидко і якісно достявляємо

Наша компанія виконує доставку по всій Росії і ближньому зарубіжжі

Гарантія якості і сервісне обслуговування

Ми пропонуємо тільки ті товари, в якості яких ми впенені

Повернення товару протягом 30 днів

У вас є 30 днів, для того щоб протестувати вашу покупку