Deye SE-G5.3 (5.32 kWh) - low-voltage LiFePO4 battery
Description Deye SE-G5.3
A hundred and four amp-hours: the series' largest usable energy
The SE-G5.3 is built on 104 Ah cells at 51.2 V, giving 5.32 kWh of nominal energy and 4.79 kWh of usable energy at the recommended 90 % depth of discharge. Four per cent of extra capacity against the standard 100 Ah modules looks trivial, but across a six-module set it already amounts to more than a kilowatt-hour of additional usable energy. The 43.2–57.6 V range is standard for the 48-volt class, so electrically the module complicates inverter selection in no way. Its 44 kg matches the rest of the SE-G series' desk-sized modules. For a system that has to squeeze the maximum usable kilowatt-hours out of a fixed number of cabinet slots, this is the densest option in the series.
Four thousand cycles instead of six: the main trade-off
This model's life is rated at 4000 cycles at 90 % depth of discharge, while the SE-G5.1 Pro B (item 1946) and the basic SE-G5.1 (item 1947) declare at least 6000. Multiply it out to see the real scale: 4000 × 4.79 kWh gives about 19.2 MWh of throughput, while 6000 × 4.6 kWh on the Pro B gives roughly 27.6 MWh. In other words, across its whole service life the older model can pass nearly a third more energy despite its smaller per-cycle capacity. This is not a hidden defect but a difference of cell generations, and it is reflected directly in the price. The practical conclusion: compare these two batteries by total lifetime energy rather than by the kilowatt-hours printed on the case.
When four thousand cycles is more than enough
Cycle count matters only when you actually spend the cycles. For a system working as backup against outages, the typical rate is one to three hundred full equivalent cycles a year, and even at three hundred, 4000 cycles stretch across more than thirteen years. Over such a span the cells' calendar ageing arrives first, and the difference between four and six thousand cycles simply never has time to show. Daily deep cycling is another matter: storing sun by day and fully discharging in the evening, or running on a night tariff all year round. There you perform 300–365 cycles annually, the rating is spent on schedule, and a 6000-cycle battery turns out cheaper per kilowatt-hour across its service life.
Current: a hundred amps maximum, fifty in normal operation
Maximum charge and discharge current is 100 A, while the recommended nominal figure is 50 A, and it is the second number that should guide your sizing. Fifty amps at 51.2 V is about 2.6 kW of continuous power per module, so a 5 kW inverter needs two modules and a 10 kW inverter four. The module withstands a hundred amps, but that is a limit rather than an operating point: sustained work at maximum heats the cells and shortens a service life that is already shorter than on the older models. In a multi-module set the current divides between them, so adding modules answers the question of power and the question of heating at once. Do not set the inverter's maximum charge current blindly — cap it at the sum of your set's nominal currents.
Up to 64 modules: 340 kilowatt-hours on one bus
The datasheet permits up to 64 modules in parallel, which is roughly 340 kWh nominal and about 306 kWh usable — the range of a commercial storage plant. The series is designed for gradual growth: you can start with two modules and add one at a time as needs increase. For large sets the quality of the power connection becomes decisive: a copper busbar with identical taps to each module rather than a daisy chain, otherwise the nearest modules take on more current. Control runs over CAN with one module designated master, and that is the stage where address and bus-terminator mistakes most often appear. For sets above eight modules, planning the cabinet, the ventilation and the wiring is best entrusted to an installer experienced with exactly this kind of system.
Do not mix with 100 amp-hour modules
This model holds 104 Ah while the rest of the SE-G series holds exactly 100 Ah, and such modules should not be combined on one battery bus. The BMS levels the set to its weakest element: a 104 Ah module next to 100 Ah modules simply cannot use its extra four per cent, and you pay for capacity that sits idle. Worse is what follows: differing internal capacity leads to uneven current sharing and different rates of degradation, so the set ages unevenly. The rule that holds for every battery bus without exception is one model, preferably one batch, identical cables. If you are expanding an existing system, check the datasheet of the installed modules and buy exactly the same ones.
What the card omits and what to confirm
This model's card is shorter than its neighbours': it states no case dimensions, no ingress protection rating, no warranty term, no temperature limits and no certification list. That does not mean they do not exist — the data simply did not reach the catalogue, and it is worth obtaining from us before ordering along with the datasheet for the specific batch. Three points matter especially: case depth, if the module goes into a standard 19-inch cabinet; charging temperature, if the room is cold; and the warranty term, if the system is bought for the long run. The rest of the SE-G series carries an IP20 rating and permits charging only from zero degrees, so these same limits very probably apply here. Write to us before placing the order and we will supply the manufacturer's current data.
How it differs from the neighbouring models here
The SE-G5.1 (item 1947) holds less usable energy — 4.1 kWh at 80 % DoD — but offers 6000 cycles and confirmed dimensions of 440 × 133 × 540 mm. The SE-G5.1 Pro B (item 1946) gives 4.6 kWh usable, 6000 cycles, optional heating for charging from minus twenty and a warranty of up to ten years. The SE-G5.1Pro (item 2094), with a case depth of 430 mm, is the only one in the series guaranteed to fit a standard server cabinet. The SE-G10.2 (item 1945) holds twice the energy and delivers 100 A continuous, but weighs 85 kg. If you need the greatest usable capacity per module and your system works mainly in backup rather than daily mode, the SE-G5.3 is a sensible choice.
Tell us how many cycles a year your system will perform and which inverter you have, and we will compare the cost per kilowatt-hour over the full service life for this model and the older ones in the series.
Characteristics Deye SE-G5.3
Reviews about Deye SE-G5.3 from real users
No reviews found




