Deye SE-G5.1Pro (5.12 kWh) - low-voltage LiFePO4 battery for a 19″ cabinet
Description Deye SE-G5.1Pro
A depth of 430 millimetres: the only one in the series for a server cabinet
The SE-G5.1Pro is a 100 Ah module at 51.2 V in a 445 × 133 × 430 mm housing, and the key figure here is the depth. The other models in the SE-G series have a 540 mm deep case, which in a standard 19-inch cabinet pushes them against the rear wall or past the rails, forcing you to buy an unusually deep cabinet. Four hundred and thirty millimetres fits comfortably into an ordinary 600 mm server or telecom cabinet, leaving room for a cable channel behind. The 133 mm height is three units, so a 42U cabinet could in theory hold up to fourteen modules, though in practice weight becomes the limit at 45 kg each. The card lists the installation location as a 19-inch cabinet or rack, with no wall-mount option, and that is a deliberate choice by the manufacturer.
Usable capacity of 4.61 kilowatt-hours
The module's nominal energy is 5.12 kWh, and the usable figure at the recommended 90 % depth of discharge is 4.61 kWh — and that second number appears in the datasheet as a line of its own. The difference against batteries rated at 80 % DoD is about half a kilowatt-hour per module, which in a four-module set already means two extra kilowatt-hours of usable energy. In the inverter's settings the discharge floor is best set at around 10 % so as not to leave the recommended regime: that is the regime in which the maker guarantees the declared cycle life. Deeper discharge is technically possible, since the BMS allows voltage down to 43.2 V, but cell life is spent faster in that zone. For a system cycling daily, respecting the recommended depth is the cheapest way there is to extend the battery's life.
A hundred amps maximum, fifty recommended
The datasheet separates two current figures: a maximum charge and discharge of 100 A, and a recommended nominal current of 50 A. In practice that means about 2.56 kW should be taken from one module in sustained operation, while a hundred amps is a brief or limiting regime rather than a daily norm. For a 5 kW hybrid inverter in backup, a sensible set is two modules; for 10 kW, four — and then each works in a comfortable zone rather than at its edge. Running permanently at maximum current is technically allowed, but it heats the cells and busbars, and in a passively cooled cabinet that heat does not go anywhere quickly. If you design the system around the recommended current, the set comes out slightly larger but runs quiet, cool and long.
An operating range of zero to plus fifty-five: no frost at all
This deserves attention: the card states a single operating range of zero to plus fifty-five degrees, rather than separate limits for charging and discharging as on the neighbouring models. Most batteries in the series permit discharge from minus twenty, so in frost they at least deliver energy; here the temperature limit applies to operation as a whole. In practice that means the room must be heated, or at minimum reliably above freezing throughout the winter — a server room, a heated technical room, a cabinet in warm quarters. An unheated garage, a container or an outdoor enclosure is fundamentally unsuitable for this model, and even external cabinet heating will not help unless it is guaranteed. If the room is cold, the series offers the SE-G5.1 Pro B (item 1946) with optional heating down to minus twenty.
Passive cooling and humidity from 5 to 95 per cent
The cooling concept is stated plainly in the datasheet: natural, with no fans, which means silence, no moving parts and zero maintenance of the cooling system. The price is a set of requirements for the cabinet: perforated or mesh doors, ventilation openings at the bottom and the top, and no tight packing of modules without gaps. Permitted relative humidity runs from 5 to 95 %, so air that is too dry is also bounded, though this never causes trouble in the Ukrainian climate. Maximum operating altitude is two thousand metres, which is no constraint for fixed installations here. The IP20 rating gives no protection against water at all, so nothing above the cabinet should be a pipe, a draining air conditioner or anything else that could leak.
Up to 64 modules: building a large bus
Scalability to 64 parallel modules turns the series from a home battery into the backbone of a commercial store: sixty-four modules is around 327 kWh nominal and some 295 kWh usable. In a set one module acts as master and reports the aggregated state of the whole bus to the inverter, the rest are slaves, and addresses are set by switches on the front panel. The classic self-installation mistake is duplicated addresses or a missing terminator at the end of the CAN bus: the inverter then sees only part of the capacity and communication errors appear in the log. For sets above eight modules, make the power connection through a copper busbar with identical taps rather than daisy-chaining module to module, otherwise the far modules carry less current than the near ones. All modules must be the same model and preferably the same batch.
Certification: UL1973, IEC62619, IEC61000, CE, UN38.3
The certificate set here is aimed at professional use: UL1973 is the testing of a battery as stationary storage, IEC62619 covers the safety requirements for industrial lithium systems, IEC61000 is electromagnetic compatibility, plus CE and the transport standard UN38.3. For a commercial site or a project going through technical approval, IEC62619 and UL1973 are often a direct requirement of the specification. IEC61000 matters wherever sensitive equipment works nearby: EMC certification means the battery neither creates interference nor succumbs to it. The warranty period is not stated on the card, so ask us about it before ordering along with the terms for your type of room. We will also tell you which documents can be supplied for this particular batch.
How it differs from the neighbouring models here
The basic SE-G5.1 (item 1947) is cheaper and allows wall mounting, but offers 80 % DoD, a 540 mm deep case and a five-year warranty. The SE-G5.1 Pro B (item 1946) has the same 4.6 kWh of usable capacity but adds optional heating for cold rooms, UL9540 certification and a warranty of up to ten years. The SE-G5.3 (item 2088) is slightly larger at 5.32 kWh, yet rated for only 4000 cycles. The SE-G10.2 (item 1945) holds twice the energy, but its 710 mm wide case will not fit a 19-inch cabinet at all. If you need a battery for the wall of a living space, look at the SE-F5 series — item 1940 or 1941, for example.
Send us your inverter model and the depth of your cabinet, and we will check how many modules physically fit and size the set to the recommended current.
Characteristics Deye SE-G5.1Pro
Reviews about Deye SE-G5.1Pro from real users
No reviews found




